If your garage door opener has a rolling code feature, program the HomeLink® Wireless Control System for it by following steps 1 through 5 in “Garage door opener programming in the U.S.A.” above.

Then continue with the following steps.

NOTE

The assistance of a second person may make the programming quicker and easier.

1. Locate the training button on the garage door opener motor head unit.

The exact location and color of the button may vary by brand of garage door opener.

If it is difficult to locate the training button, refer to your garage door opener’s instruction manual.

2. Press the training button on the garage door opener motor head unit (which activates the “training light” on the unit). Proceed to step 3 within 30 seconds.

3. Inside the vehicle, firmly press and release the HomeLink® button that was programmed in the section above. Press and release the button a second time to complete the programming procedure.

NOTE

Some garage door openers may require you to do the above procedure a third time to complete the programming.

4. The garage door opener should now recognize the HomeLink® Wireless Control System and your garage door opener should activate when the HomeLink® button is pressed.