Hyundai Tucson: Emergency situations
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual / Emergency situations
- Hazard warning flasher
- Jump starting
- Tire Pressure Monitoring System (TPMS)
- If you have a flat tire (equipped with spare tire)
- Towing
READ NEXT:
Hazard warning flasher
The hazard warning flasher serves as
a warning to other drivers to exercise
extreme caution when approaching,
overtaking, or passing your vehicle.
It should be used whenever emergency
repairs are being made or when the
vehicle is stopped
Jump starting
Jump starting can be dangerous if done
incorrectly. Follow the jump starting
procedure in this section to avoid serious
injury or damage to your vehicle. If in
doubt about how to properly jump start
your vehicle, we strongly recommend
that you
SEE MORE:
Compressor - Installation
Make sure that the compressor (A) mounting bolt of the correct length is
screwed in. Tighten the mounting bolts in the
specified tightening order.
Install in the reverse order of removal.
f you install a new compressor, drain
Cylinder Block - Replacement
Components
Rear oil seal
Replacement
Remove the fly wheel.
(Refer to Cylinder Block - "Fly Wheel")
Remove the rear oil seal (A).
Apply engine oil on the edge of new rear oil seal.
Using SSTs (09231-H1100, 09231
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
